Variable speed belt
The variable speed belt has two kinds of structures, which are wrapping cloth or cutting edge.The cast teeth reduce heat accumulation or stress concentration and extend the life of the belt.The smooth running structure allows the belt to operate at high speed with only minor changes.Meet RMA oil - proof, heat - resistant standards.Gates variable speed with RMA standard, ISO standard, gates special specifications.
Variable speed belt
The foreign name is Variable speed belt
The special color has two kinds of structure: cloth wrapping or edge cutting
Special point has high bearing capacity and long life
The characteristics of
1. The variable speed belt has two kinds of structures, including wrapping cloth or cutting edge. The special rubber fiber characteristics determine that it has both high lateral rigidity and longitudinal flexibility, high bearing capacity and long life.
2. The cast teeth reduce heat accumulation or stress concentration, and extend the life of the belt.
3. The smooth running structure makes the belt change only slightly at high speed.
4. Meet the RMA oil proof and heat resistance standards.
Gates variable speed with RMA standard, ISO standard, gates special specification.
The detailed information
Belt length: from 647 mm to 3150 mm
Note: HV represents an overloaded structure
Narrow and wide triangular belts
The ratio of width to height is 1:1.5 ~ 1.6. The triangular bands of narrow type and wide type are 1:1 respectively.2 and 1:2.Narrow v-belt type structure size than ordinary v-belt can reduce about 50%, can save a lot of raw materials, strength even at the same time, the effective contact area is large, the bending stress is small, can significantly extend the service life.The transmission efficiency of narrow v-belt can reach 90%-97%, the ultimate speed is 40-50m/s, and the transmission capacity is increased by 0.5 ~ 1.5 times, most suitable for short distance, small belt wheel in the speed transmission, so called as speed belt.Its features are on the upper and lower surfaces of the belt, most of which are made into single or double curved or toothed states, making it easy to adjust speed, mainly used in low speed cone type and disc type stepless transmission.